In the production of organic fertilizers, after all when using organic fertilizers, it is impossible to say that the newly produced organic fertilizers will be packaged and transported. Typically, some shape manipulation will be done. At this time, an organic fertilizer granulator is needed. Common organic fertilizer granulators include: npk fertilizer granulator, drum granulator, disc granulator machine, new organic fertilizer granulator, new two-in-one organic fertilizer granulator, flat die granulator, etc. What should we prepare before shape processing?
When the organic fertilizer granulator machine is running, reflect whether the water, electricity, and gas systems in the equipment are normal, ensure that the water and gas paths are unblocked, without leakage, whether the electrical system is normal, whether the heating system, temperature control, and various instruments are reliable; the auxiliary machine low-speed test Run, observe whether the organic fertilizer production equipment can operate normally; start the vacuum pump of the setting table, and observe whether the responsibility is normal; the lubrication position of various equipment. If any defects are found, they should be removed in time. Install the machine head and setting sleeve, select the machine head specification according to the product variety and size, and install the machine head according to the following sequence.
The granulator operation can be started at constant temperature at start-up. Before starting, the bolts of the machine head and the flange of the granulator should be tightened again to eliminate the difference between the thermal expansion of the bolts and the machine head. When tightening the bolts of the machine head, the angle should be tightened, and the force should be symmetrical. When tightening the flange nut of the machine head, it is required that the four sides are tight and tight, otherwise it will run away.
When operating the organic fertilizer granulator machine, choose to press the "ready to drive" button, then connect the "drive" button, and then slowly change the screw speed recovery knob, and the screw speed starts slowly. Then gradually speed up, but also with a small amount of feeding. And add enough materials according to the needs, the twin-screw granulator operation selects the metering feeder evenly, so that the organic fertilizer granulator can granulate more effectively.
